AT&T UNIX Telephone Manager User Manual page 5

Telephone Manager 3.51 Important Information
4
You may also display a picture of a dial pad
and place a voice call to any number by using
the telephone icon and the mouse. To use the
mouse and dial pad:
a Point to the telephone icon with the mouse
and press <Bl>. The magic wand appears.
Press <Bl> again, or press <B2> if you
are not still pointing at the telephone
icon. A dial pad appears, and the magic
wand becomes a hand with a pointing finger
as you move it over the pad.
b with the pointing finger, point to each
digit in the telephone number and press
<Bl>. Each digit appears at the top of
the window.
c When you have entered the complete
telephone number, point to [DIAL] and
press <Bl>.
Three other keys are on the dial pad: [BACK],
[WAIT] and [LAST
#].
[BACK] works like a
backspace key, and lets you correct mistakes
made while entering numbers. [WAIT] causes
the call to wait for a secondary dial tone
before proceeding, and is shown as an equals
sign (
= ).
[LAST #] shows the last number
dialed at the top of the window, which may then
be redialed.
5 On single line systems that are set to VOICE
mode, when you place a da ta call from the
console, the Telephone Manager will
automatically switch the line to DATA mode.
After the data call is complete, the line
switches back VOICE mode.