Barcomed Driver Tab; Introduction - Barco DICOM THEATER System Manual

BARCOMED DRIVER TAB

Introduction

After the BarcoMed Windows Display Controller Driver is installed, a
new Display Properties tab is available for configuring special features
of the BarcoMed Display Controller. Please note that you must have
logged on to Windows using an account with administrator privileges in
order to use the BarcoMed Tabs of the Windows Display Control Panel
to change any display settings.
1) Open the "Display Properties Control Panel" by right clicking on the
desktop, then select "Properties"..
2) Under Windows NT 4.0, Click on the "BarcoMed Driver" Tab (see
figure 23, below).
Under Windows 2000, click on "Settings" tab. Double click on the
rectangle that represents the BarcoMed Display Controller to bring
up its property page. Click on the "BarcoMed Driver" tab
(see figure 24 on the next page).
Under Windows XP, click on "Settings" tab. Double click on the
rectangle that represents the BarcoMed Display Controller to bring
up its property page. Click on the "BarcoMed Driver" tab
(see figure 25 on the next page).
Figure 23: BarcoMed Driver Tab under Windows NT 4.0
System manual DICOM Theater 46