Table of Contents
Advertisement
Figure 13: The Windows 2000 Display Properties Control Panel Settings Tab
after the driver have been installed and the resolution set.
Note: The system shown in figure 13 above is a single BarcoMed
Display Controller, no 3
may look different.
Reinstalling or Updating your BarcoMed 2MP1HP Driver
To reinstall or update only the BarcoMed Driver, follow the steps
described in the section "Using the BarcoMed Product Installation
Wizard" found at the beginning of this chapter with the following
changes.
1. Skip Steps 1, 2 and 4.
2. In Step 6, clear the checkbox next to the BARCO DPMS.
3. When the driver has finished installing, click "Finish". Then click
"Finish" again.
4. Reboot the system when prompted and then reset the resolution of
your displays if necessary.
System manual DICOM Theater
rd
party VGA card configuration, your system
37
Advertisement
Table of Contents
