Installation With Additional Data Source - Barco DICOM THEATER System Manual

Installation with additional data source

This installation allows using the projector for other purposes, e.g.,
projecting presentations.
Head A
Head B
Proceed as follows:
1 Connect Head A from the workstation imaging board to the first
display's VGA video input by means of the D-Sub15-to-D-Sub15
cable.
2 Connect Head B (marked "Projector out") from the workstation
imaging board to the projector BNC video input by means of the D-
Sub15-to-5 BNC cable (15m / 50ft).
3 Connect the video output from the second data source to the
projector VGA video input by means of a VGA cable. This cable is
not provided in the standard Dicom Theater package.
4 Connect a free PC COM port to the projector RS-232 connector by
means of the D-Sub9-to-D-Sub9 cable (15m / 50ft).
5 Connect a free PC USB connector to the display USB In connector
by means of a USB-to-USB cable.
6 Connect the optical sensor to another free PC USB bus. If the cable
is not long enough, you have to use a USB booster/extender.
Installation of the sensor is described more in detail in the section
"MediCal and Dicom Theater software installation and usage".
System manual DICOM Theater
Optical sensor
Video out
COM port
USB out
BNC in
RS-232 in
VGA in
VGA in
USB in
15