Lubrication - Siruba Sew Reach D007S Instruction Book

潤滑
1. 潤滑油
絕對不要在油內加入任何添加物（劑），否
則將惡化油的品質，並損害機器。
2. 潤滑系統
(1) 旋開油塞螺絲①和②然後加油。（圖 4）
(2) 從油孔①加油直到油量到③最上方的紅
線，從油孔②加油直到油量到④最上面
的紅線。（圖 5）
(3) 使用機器前檢查油水平。如果沒到水平線
要加油。
(4) 當機器在使用中時，從油鏡⑤和⑥檢查油
有無供應。
注意：
太多或太少的油會造成機器漏油和機器故障。
維持油的水平在 2 條紅線之間。
P9

LUBRICATION

1.Lubricant
Never add additives into the oil, otherwise,
it would deteriorate the quality of oil and
machine damage.
2.Lubrication system
(1)Remove plug screw①, ②, and lubricate.
(2)From plug screw ①, supply oil until it
(3)Check the oil level before using the
(4)Check whether oil have supplied or not
Caution：
Too much oil or not enough oil may cause oil
leakage and machine malfunction. Keep the
oil level between two red lines.
③
⑤
①
(Fig. 4 )
reach the upper red line③, from plug
screw ② supply oil until it reach the upper
red line ④.(Fig. 5 )
machine. Supply oil if didn't reach the
level.
through oil sight top window ⑤, ⑥ during
machine operating.
②
⑥
④
圖 4/ Fig.4
圖 5/ Fig.5