Siruba Sew Reach D007S Instruction Book page 32

4. 前護針片
當勾針③在左針中間時，推前護針片①，使
針和下勾針的間隙為 0mm。放鬆螺絲②去
調整它。當下勾針左移到右時，檢查下勾針
③有無碰到針的後面，看針有無左右移動。
③
②
5. 後護針片
當後護針片④和針最靠近的時候，要有
0.05-0.1mm 的間隙。由螺絲⑤去調整。
當下勾針從左移到右時，後護針片不能碰到
針。
注意：
當有調整針距時，注意後護針片要重新整調。
P29
①
圖 56 / Fig. 56
④
⑤
4.Front needle guard
Push the front needle guard ① so that
the clearance between the needle and the
looper is 0mm when the looper ③ comes at
the center of the left needle. Loosen screw
② to adjust it.Check whether lower looper
③ touch the back of the needle and needle
have moved left and right, while lower looper
move left from the right.
③
①
③
空隙 Clearance: 0 mm
5.Rear needle guard
Make the clearance between the rear needle
guard④ and the needle to 0.05-0.1mm when
they meet most closely. Use screw ⑤ to
adjust.
The rear needle guard shall not touch the
needle when the lower looper move from the
left to right.
Caution：
Be careful to readjust the rear needle guard
when adjust the distance of needle.
③
①
0.05-0.1 mm
①
圖 57 / Fig.57
圖 58 / Fig. 58