Siruba Sew Reach D007S Instruction Book page 13

3. 啟動注油
裝新機器或使用久未使用的機器，如果油沒
有循環完整，需移除幫浦上的油塞螺絲①，
注入油後裝回螺絲再使用機器。（圖 6）
4. 補充油
在箭頭處需滴一些油潤滑。如果油漏在壓腳
和上刀周圍會導致沾汙布，要確實的把油擦
乾淨。（圖 7、圖 8、圖 9）
3.Priming oil
Prime oil by removing plug screw ①, if oil
does not circulate completely when installing
a new machine or running a machine which
has not been used for a while. Use the
machine after priming oil.(Fig. 6 )
①
4.Replenishing oil
Replenish drops of oil at the arrow direction
to lubricate. If oil leaks around the presser
foot or upper knife, it can cause oil stain on
the material. Be sure to wipe it completely.
（Fig. 7、8、9）
圖 7/ Fig.7
Introduction
圖 6/ Fig.6
圖 8/ Fig.8
圖 9/ Fig.9
P10