Introduction PRODUCT SPECIFICATION 產品規格 1. 規格 1. Specification 規格 Specifications 標準值 Standard value 針棒行程 Needle bar stroke 33±0.5 mm 左針高度 Left needle height 9.5 mm 送具高度 Feed dog height 0.8~1.2 mm 押具揚程 Presser foot lift 5 mm 使用針 Needle UYX128GAS#10 上送齒上下行程...
PART NAMES 各部件名稱 圖 1 / Fig. 1 Top feed stroke adjust button 上送行程調整鈕 Top feed dog 上送具 scale adjustment hand wheel 刻度調整手輪...
Page 5
Introduction ADJUSTMENT 調整 1. 上送齒行程大小之調整 ( 圖 2) 1. Adjust the top feed stroke (Fig. 2) 行程大小由 1.5~5.5mm 無階段性調整 Adjust the stroke from 1.5 to 5.5mm without periodic adjustment (1. ) 用左手壓下按鈕 (1. ) Press button with left hand , and turn the ,再以右手轉動手輪直...
Page 6
2. 壓具壓力強度之調整 2. Adjust the presser foot strength Lighten the presser foot as much as possible 在布料推送順暢且縫合完美的情況下,盡量 when the fabric can be fed smoothly and 使壓具壓力輕一點。 stitched perfectly. * Loose the screw nut . When the screw rod *鬆開螺帽 ,將螺桿 順時針旋轉壓力...
Page 18
由於對產品的改良及更新 , 本產品使用說明書中與零件圖之產品及外觀的修改恕不事先通知 ! The specification and/or the equipment described in the instruction book and parts list are subject to change because of modification with out previous notice FFT66.FEB.2014...