Siruba Sew Reach D007S Instruction Book page 33

6. 送布齒
(1) 安裝：
固定差動的送布齒和主要送布齒③用螺絲
②和④固定後，護針片⑤在主送布齒上調
整時，鬆開螺絲⑥。
(2) 高度：
當送布齒在最高點時，主送布齒③和針板
的高度為 1.2-1.5mm，前後送布齒必須保
持一樣的高度。
(3) 高度微調：
送布齒的高度後調要旋轉偏心銷⑧來控
制。放鬆螺絲⑦然後調整偏心銷⑧的高
低。
˙ 順時針旋轉偏心銷⑧調高送布齒。
˙ 逆時針旋轉偏心銷⑧降低送布齒。
1.2-1.5mm
③
A
④
A
圖 60 / Fig. 60
6. Feed dog
(1) Installation：
Use screws ②④ to fixed differential feed
dog and main feed dog ③. Loosen screw
⑥, when needle guard ⑤ adjust on the
main feed dog.
(2)Height：
The main feed dog ③ and needle plate at
the height 1.2-1.5m, when the feed dog is
at the highest point. Align the differential
feed dog with main feed dog at the same
height.
(3) Fine adjustment of height：
Turn the pin ⑧ to adjust the height of the
feed dog. Loosen screw ⑦, then adjust
the height of the pin ⑧.
˙ To raise the feed dog, turn the pin ⑧
clockwise.
˙ To lower the feed dog, turn the pin ⑧
counterclockwise.
①
②
⑤
⑥
Lower 降低
Introduction
圖 59 / Fig. 59
⑦
⑧
調高 Higher
圖 61 / Fig. 61
P30