Way Of Threading - Siruba Sew Reach D007S Instruction Book

穿線方法
先用易穿的線從 ABCDEF 孔穿至針鎦前，然後
結上要用的線拉到針前，把結剪掉。
線正確位置：（圖 12）
A、 B、C、D：針線
E：上飾線
F：下勾針線
提醒：
當抬起壓腳時，線架組會平穩的放開，此時可
輕鬆的將線拉過。
穿下鉤針線時不須把針板拆掉。
注意：
穿線前一定要先把電源關掉，並確定馬達完全
停止。

WAY OF THREADING

Use the thread which easy to get through the
needle eyes ABCDEF, then knots the threads
and pull the threads in front of needle. Cut off
the knots.
Correct position of the thread：(Fig. 12 )
A , B , C , D：Needle thread
E：Top cover thread
F：Lower looper thread
Note：
When raising presser foot, thread guide plate
will loose steadily, and could pull out the
thread easily.
Do not need to take off needle plate to thread
lower looper thread.
Caution：
Before threading, must turn off the power and
make sure the motor is stop completely.
E
F
A B C D
Introduction
圖 12 / Fig. 12
P12