Connecting The San Volume Controller 2145-Cf8 To The San And To The Ethernet Network - IBM 2145-CF8 Hardware Installation Manual

Connecting the SAN Volume Controller 2145-CF8 to the SAN and
to the Ethernet network
The diagram and text labelling was incorrect, replace the first two instructions.
Page 34.
To connect the SAN Volume Controller 2145-CF8 to the SAN and to the Ethernet
network, perform the following steps:
1. Connect an Ethernet cable to Ethernet port 1, as shown by 9 in the figure below. If
required, connect the second Ethernet cable to Ethernet port 2 (8).
2. Connect the other end of the Ethernet cable(s) to the proper connector(s) on the
Ethernet hub or switch.
1 Fibre-channel port 1
2 Fibre-channel port 2
3 Fibre-channel port 3
4 Fibre-channel port 4
5 Power supply 1 connector
6 Power supply 2 connector
7 Serial port
8 Ethernet port 2
9 Ethernet port 1
Attention: When routing the fibre-channel cables, do not tighten the cable straps or bend
the cables to a radius smaller than 76 mm (3 in.).
© Copyright IBM Corp. 2009, 2010 9