Reassembly And Remounting - Suzuki DR-Z70 Service Manual

5-30 CHASSIS
SWINGARM PIVOT SHAFT
Measure the swingarm pivot shaft runout using the dial gauge. If
the pivot shaft exceeds the service limit, replace it with a new
one.
09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block (100 mm)
Swingarm pivot shaft runout
Service Limit: 0.6 mm (0.02 in)

REASSEMBLY AND REMOUNTING

Reassemble and remount the swingarm in the reverse order of
removal and disassembly. Pay attention to the following points:
• Install the swingarm.
• Tighten the swingarm pivot nut to the specified torque.
Swingarm pivot nut: 42 N·m (4.2 kgf-m, 30.5 lb-ft)
• Tighten the rear shock absorber mounting nuts to the speci-
fied torque.
Rear shock absorber mounting nut:
After installing the rear suspension and wheel adjust the follow-
ing.
* Drive chain slack ...................................................
* Rear brake pedal free travel .................................
50 N·m (5.0 kgf-m, 36.0 lb-ft)
2-13
2-14