Suzuki DR-Z70 Service Manual page 78

DISASSEMBLY
• Remove the starter driven gear.
• Holding the generator rotor with the special tool, remove the
starter clutch bolts 1 .
09930-44530: Rotor holder
• Remove the starter clutch 2 from the rotor.
INSPECTION
Inspect the starter clutch for damage and excessive wear. If any
defects are found, replace the starter clutch with a new one.
Inspect the starter driven gear for wear or damage. If any
defects are found, replace the starter driven gear with a new
one.
REASSEMBLY
Reassemble the starter clutch in the reverse order of disassem-
bly. Pay attention to the following points:
• Install the starter clutch in the proper direction as shown.
• Apply engine oil to the starter clutch.
• Apply THREAD LOCK SUPER "1322" to the bolts.
99000-32110: THREAD LOCK SUPER "1322"
• Holding the generator rotor with the special tool, tighten the
starter clutch bolts 1 to the specified torque.
Starter clutch bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
09930-44530: Rotor holder
ENGINE 3-46