Table of Contents
Advertisement
TaiShan 200 Server
User Guide (Model 2280)
Set the PXE
●
●
Issue 04 (2020-01-16)
Setting the PXE for an LAN on motherboard (LOM)
a.
Select Advanced and press Enter.
The Advanced screen is displayed, as shown in
Figure 5-47 Advanced screen
b.
Select LOM Configuration > PXE Configuration and press Enter.
c.
Set the PXE for NICs.
i.
Select the network port such as PXE1 Configuration, and press
Enter.
ii.
In the dialog box that is displayed, select Enable and press Enter.
d.
Select PXE Boot Capability and press Enter. In the dialog box that is
displayed, select the PXE boot network protocol.
▪
UEFI: IPv4
▪
UEFI: IPv6
▪
UEFI: IPv4/IPv6
e.
Press F10.
The system displays "Save configuration changes and reset and exit?"
f.
Select Yes and press Enter to save the setting.
Setting the PXE for a NIC connected to the server
The displayed information varies according to the external NIC when you configure
the PXE. The following procedure uses the SP570 NIC as an example.
Copyright © Huawei Technologies Co., Ltd.
5 Install and Configure
Figure
5-47.
87
Hide quick links:
Advertisement
Table of Contents
