Fault Signaling Relay K1 - Advanced Energy THYRO-AX Manual

48
DESCRIPTION THYRO-TOOL AX MESSAGE
OF STATUS MESSAGE ON DISPLAY
PULSES ARE SWITCHED ON IMPULSE ON PULSE ON
PULSE OFF AT PULSE SWITCH OFF PULOFFT
TERMINAL X2.1-X2.2 TERMINAL
PULSE OF AT PULSE SWITCH OFF PULOFFHW
HARDWARE (ERROR) HARDWARE ERROR
PULSE OF AT SOFTWARE PULSE SWITCH OFF PULOFFEV
(CONFIGURABLE) EVENT
PULSE OF EXTERNAL PULSE SWITCH OFF PULOFFEX
EXTERN
LEFT ROTATING FIELD LEFT ROTATING FIELD LEFTROTF
(MESSAGE ONLY)
U LIMIT U LIMIT U LIMIT
I LIMIT I LIMIT I LIMIT
P LIMIT P LIMIT P LIMIT
IPEAK LIMIT I PEAK LIMIT IPEAKLIMIT
ALPHA IS RESTRICTED ALPHA RESTRICTED ALPHA
TS IS RESTRICTED SWITCH ON TIME TS
RESTRICTED
MAXIMUM CONTROLLER MAXIMUM OUTPUT MAXCONTROL
OUTPUT IS REACHED REACHED
SETPOINT OF BUSMODULE BUSMODULE BUS SETP
IS ACTIVE SETPOINT ACTIVE
BUSMODULE IS CONNECTED BUSMODULE BUS CONN
CONNECTED
CLOCK IST NOT SET CLOCK NOT SET NO CLOCK
POWER UNITS ARE HIGHER POWER UNIT DIFF PPART
THAN TYPE DIFFERENT
POWER CONTROLLER IS OK POWER CONTROLLER THYRO OK
OK
* = cannot be deactivated
** = default setting of fault signaling relay K1: closed circuit principle
TAB. 5 STATUS
DISPLAY RELAY** PULSE INHIBIT DATA
LIGHTING RED LOGGER
-
X -
X - X
X - X
X -
X X X
X
X
X
X
X
-
DESCRIPTION THYRO-TOOL AX MESSAGE
OF MONITORING MESSAGE ON DISPLAY
U MIN U MAIN < MINIMUM UN MIN
MAINS
U MAX U MAIN > MAXIMUM UN MAX
MAINS
U MIN U < MINIMUM UL MIN
LOAD
U MAX U > MAXIMUM UL MAX
LOAD
I MIN I < MINIMUM IL MIN
LOAD
I MAX I > MAXIMUM IL MAX
LOAD
P MIN P < MINIMUM PL MIN
LOAD
P MAX P > MAXIMUM PL MAX
LOAD
R MIN R < MINIMUM RL MIN
LOAD
R MAX R > MAXIMUM RL MAX
LOAD
I MAX I PEAK > MAXIMUM I_PEAK MAX
PEAK
MAX. TEMP. OF HEAT SINK TEMPERATURE UNIT > T_HEAT MAX
MAXIMUM
* = cannot be deactivated
** = default setting of fault signaling relay K1: closed circuit principle
TAB. 6 MONITORING
The events, which are captured by the Thyro-AX, are shown on the
touch display in abbreviated form in a list. They correspond with the full
forms in their meaning and can be discerned using the table above.

6.8.2 FAULT SIGNALING RELAY K1

NOTE
DEFAULT SETTING
The function explained here is described in its default setting.
This setting can be altered with the control panel, with a bus module,
or with the Thyro-Tool AX.
49
DISPLAY RELAY** PULSE INHIBIT DATA
LIGHTING RED LOGGER
X
X
X
X
X
X
X
X
X
X X X
X
X X X
FIG. 7 CONTACT
ASSIGNMENT
FAULT
SIGNALING
RELAY K1