General Danger Information - Advanced Energy THYRO-AX Manual

14
The warnings can also be supplemented with a special danger symbol
(e.g. „Electric current" or „Hot device") , e.g.
in case of risk of electric current or
in case of risk of burns.
In addition to the warnings, there is also a general note for useful
information.
NOTE
Content of note

2.2 GENERAL DANGER INFORMATION

DANGER
ELECTRIC CURRENT
Hazards that can lead to serious injuries or fatal injuries.
WARNING
ELECTRIC CURRENT
Risk of injury from current carrying parts
• Never operate the device without covering.
CAUTION
HOT DEVICE
Risk of burns from heat sinks and adjacent plastic parts (> 70 °C possible)
Do not touch the hot parts of the device.
Affix the warning sign "Risk of burns" in the immediate vicinity of the
device.
DANGER
HAZARDS DURING INSTALLING
Not adhering to the safety requirements in the operating instructions of
the power controllers being used can lead to danger of injury/danger
of damaging the device or system.
- Adhere to all safety requirements in the chapter "Safety" of the ope-
rating instructions of the power controllers being used.
DANGER
UNSAFE SYSTEM DUE TO INCORRECT INSTALLATION
Incorrect installation can lead to unsafe operation of the system.
Therefore it is essential to maintain the following specifications:
- Only install the device in an upright position.
- Ensure sufficient ventilation and de-aeration of the cabinet if mounted
in a cabinet.
- Observe minimum spacing (self-ventilated: clearance: 150 mm above,
100 mm below). The devices can be installed next to one another
without spacing between.
- Ensure that the device cannot heat up as a result of heat sources from
below (the power loss is listed in the type overview table, see chapter
Technical data).
- Ground the device in accordance with the local regulations (ground
screw/bolt for protective conductor connection on the heat sink). The
grounding also serves for EMC means (Y - capacitor 4.7 nF + 12 M ).
- Cover energized parts
CAUTION
USE OF INCORRECT CONNECTION CABLES
Incorrect connection cables can lead to functional faults.
Use shielded control cables to connect the control signals.
For use in UL conditions: for power connections only use 60 °C or 75 °C
copper conductors (in accordance with the information in the Technical
data).
15