Sensor Monitoring; Setting The Timer; Drop-Out Or Pick-Up Delay - MICRO-EPSILON colorCONTROL MFA-1 Instruction Manual

Operation and Settings
6.9
If the signal received by the sensor receiver is too weak due to contamination or a sensor fault, the
will light up.
6.10
i
Use the
First press of the button
2 - 11
The
6.11
i
Default setting: OFF delay = drop-out delay
If you keep the
Repeat this step to change back to OFF delay.
colorCONTROL MFA-1

Sensor Monitoring

Setting the Timer

The timer can only be enabled in setup mode.
SET
Press the button for 4 seconds until the symbol starts blinking.
t
and buttons to increase or reduce the value.
Lo-Do
t = 40 ms
t = +500 ms
t
symbol starts blinking when t > 0 ms.
SET
Press the button once to set the timer to 0.
t

Drop-out or Pick-up Delay

After setting the timer you need to select the type of delay.
button pressed for 4 seconds, the delay type changes to ON delay = pick-up delay.
SET
Press the button again to return to operating mode.
t
Δ
symbol
Page 30