Install The Ptx5000 Mounting Hardware For An Open-Frame Rack; Install Cage Nuts, If Needed - Juniper PTX5000 Quick Start Manual

Figure 3: Removing the Center-Mounting Bracket
Center-mounting bracket

Install the PTX5000 Mounting Hardware for an Open-Frame Rack

Install Cage Nuts, If Needed | 11

1.
Install the Open-Frame Rack Mounting Shelf | 13
2.
Install Cage Nuts, If Needed
Insert cage nuts, if needed, into the holes listed in
distances are relative to the standard U division on the rack that is aligned with the bottom of the mounting
shelf and rear support bracket.
To install cage nuts in an open-frame rack:
1. On the rear side of both rack rails, insert cage nuts in the holes specified for the open-frame mounting
shelf (see Table 3 on page
Table 3 on page 12
12).
and Table 4 on page 12. The hole
11