Tools Required To Unpack And Install The Ptx5000 - Juniper PTX5000 Quick Start Manual

For service personnel to remove and install hardware components, there must be adequate space at the
front and back of the chassis. At least 24 in. (61.0 cm) are required both in front of and behind the
PTX5000. NEBS GR-63 recommends that you allow at least 30 in. (72.6 cm) behind the rack.
Additional clearance is required to accommodate the depth of the following components:
Front cable management system—3.8 in. (9.7 cm) additional depth in the front of the chassis.
Front door—5.5 in. (14 cm) additional depth in the front of the chassis.
Rear cable management system—5.5 in. (14 cm) additional depth in the rear of the chassis.
Figure 1: Chassis Dimensions and Clearance Requirements

Tools Required to Unpack and Install the PTX5000

Gather the tools required to unpack the PTX5000:
Phillips (+) screwdriver, number 2
1/2-in. or 13-mm open-end or socket wrench to remove bracket bolts from the shipping pallet
Blank panels to cover any slots not occupied by a component
Gather the tools required to install the PTX5000:
Mechanical lift
Phillips (+) screwdriver, number 2
5