Table of Contents
Advertisement
2.1.3 DSLAM Rear Panel
The rear panel of the DSLAM indicates an AC inlet power socket, which accepts input power from 100 to 240V AC, 50-60Hz.
Figure 2-3
shows the rear panel of the DSLAM.
DSLAMP Rear Panel
■ AC Power Receptacle
For compatibility with electrical service in most areas of the world, the DSLAM's power supply automatically adjusts to line
power in the range of 100-240V AC and 50/60 Hz.
Plug the female end of the power cord firmly into the receptacle on the rear panel of the DSLAM. Plug the other end of the
power cord into an electrical service outlet and the power will be ready.
The device is a power-required device, which means it will not work till it is powered. If your networks
should be active all the time, please consider using UPS (Uninterrupted Power Supply) for your device.
It will prevent you from network data loss or network downtime. In some areas, installing a surge
suppression device may also help to protect your DSLAM from being damaged by unregulated surge or
current to the DSLAM or the power adapter.
2.2 Installing the DSLAM
This section describes how to install your DSLAM and make connections to the DSLAM. Please read the following topics and
perform the procedures in the order being presented. To install your DSLAM on a desktop or shelf, simply complete the
following steps.
2.2.1 Rack Mounting
To install the DSLAM in a 19-inch standard rack, please follow the instructions described below.
Step1:
Place the DSLAM on a hard flat surface, with the front panel positioned towards the front side.
Step2:
Attach the rack-mount bracket to each side of the DSLAM with supplied screws attached to the package.
Figure 2-3: Rear Panel of DSLAM
- 16 -
Advertisement
Table of Contents
