Table of Contents
Advertisement
[Dnstream] Min INP
[Dnstream] Min INP8
[Upstream] Max Rate (kbps)
[Upstream] Min Rate (kbps)
[Upstream] Msg rate (kbps)
[Upstream] Max SNRM (0.1dB)
[Upstream] Min SNRM (0.1dB)
[Upstream] Target SNRM
(0.1dB)
[Upstream] Max Interleave
Delay (ms)
[Upstream] Min INP
[Upstream] Min INP8
Button
: Save configuration.
: Click to reset IP address to default setting.
: Click to delete current xDSL profile.
: Click to delete all xDSL profiles.
Default: 4ms
Allows user to configure downstream minimum INP from 0.5 symbols to 16
symbols. (INP means impulse noise immunity) Default: 0.5 symbols.
Allows user to configure downstream minimum INP8 from 0.5 symbols to 16
symbols. Default: No INP8
Allows user to configure upstream maximum rate from 32 to 200000.
Default: 20000
Allows user to configure upstream minimum rate from 32 to 200000. Default:
32
Allows user to configure upstream rate from 4 or 248 kbps. Default: 16.
Allows user to configure upstream SNR margin maximum from 60 to 310.
Default: 310dB
Allows user to configure upstream SNR margin minimum from 0 to 60.
Default: 0dB
Allows user to configure upstream target SNR margin from 0 to 310.
Configured acceptable SNR margin. If the SNR margin is above this value,
the CO should attempt to reduce its power output to optimize its operation.
Default: 80dB
Allows user to configure maximum upstream interleave delay from 0 to
63ms. Interleave Delay defines the mapping (relative spacing) between
subsequent input bytes at the interleave input and their placement in the bit
stream at the interleave output.
Default: 16ms
Allows user to configure downstream minimum INP from 0.5 symbols to 16
symbols. (INP means impulse noise immunity) Default: 0.5 symbols.
Allows user to configure downstream minimum INP8 from 0.5 symbols to 16
symbols. Default: No INP8
- 50 -
Advertisement
Table of Contents
