Raid System And Device Startup - Siemens SIMATIC IPC847D Operating Instructions Manual

A.3

RAID system and device startup

Problem
The RAID software reports
the following errors:
The RAID plug-in failed
•
to load, because the
drive is not installed.
The Serial ATA plug-in
•
failed to load, because
the driver is not installed
correctly.
The Intel Matrix
• ®
Storage Console was
unable to load a page
for the following reason:
– A plug-in did not
provide a page for
the selected device
– A plug-in failed to
load
After changing the drive, the
system does not boot from
the RAID system
After changing the drive,
"unused" is indicated for the
relevant SATA port
SIMATIC IPC847D
Operating Instructions, 01/2014, A5E32997454-AA
Cause
RAID is not activated
RAID is activated
RAID system does not have
highest boot priority
System was booted without
functioning drive. The
removable drive bay might
not be switched on.
A.3 RAID system and device startup
Remedy
The messages have no negative effect on the operation of the
device and can be ignored.
Acknowledge the messages.
Install the software again from the supplied "Documentation
and Drivers" DVD.
BIOS setup, Boot menu:
Permit RAID system in the boot priority
•
Set the RAID system to be first in the boot priority order.
•
Reboot the system with a functioning drive.
Technical support
197