Table of Contents
Advertisement
No filament coming
out.
Extruder will not
home.
Stringy or fraying
plastic layers on
steep overhangs.
8.2 Unlogging the extr uder
Use the unclogging tool to clean the extruder and unclog built up filament
1. Click on the filament change button on the screen and wait for extruder to heat up.
As filament starts to purge, insert the unclog tool into the extruder intake (top).
2.Clogged debris will be pushed down and will extrude from the extruder nozzle. You
should push the unclog too all the way down to ensure all filament is purged. You do
not need to push with excessive force, as this may damage the extruder.
8.3 Daily maintenance and use suggestion
1.Please cover the top and close the front door to prevent the device from falling into
dust when not using the device.If the device has not been used for a long time, it is
recommended to use the original packaging.
2.Grease moving parts regularly.For frequent users, add grease at least once every
Finder User Guide | www.flashforge.com
Clogged extruder.
Filament not properly loaded.
／
Object overhangs are too far
apart or too steep (<45 degree
angle).
75
Contact customer service.
Try running a lament change again to
ensure the extruder gears have properly
caught the lament.
Contact customer service.
Build with supports.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Finder and is the answer not in the manual?
Questions and answers