Table of Contents
Advertisement
（3-5）Discard the blue tape that holds the flat cable in place. Be careful with the flat
cable.
3-6
(3-6) Cut off the four ribbons that used for fixing the guide rod. Then slide the
extruder to make sure the extruder is in good condition.
3-7
(3-7) Remove the middle insert. A spool of filament is packed inside.
3-8
Finder User Guide | www.flashforge.com
27
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Finder and is the answer not in the manual?
Questions and answers