Table of Contents
Advertisement
(5-2) After tapping [OK], the extruder starts to move towards the first point and the
plate moves up and down to verify the distance between nozzle and plate.
(5-3) When it shows that the distance is too small, please screw corresponding nut
under platform counterclockwise; When it shows that the distance is too big, please
unscrew all three nuts under platform clockwise; Until hearing a steady beep and the
[Ver ify]
button appears.
(5-4) If the distance is appropriate, tap
please follow the prompts to adjust again till you see
(5-5) Repeat steps 2 through 4 according to the prompts on the touchscreen to complete
second and third points leveling and then Tap
Finder User Guide | www.flashforge.com
5-3
5-4
[OK]
to second point leveling. If still not,
[OK]
5-5
[Finish]
to exit.
34
button.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Finder and is the answer not in the manual?
Questions and answers