FLASHFORGE 3D PRINTER Finder User Manual page 23

Accessories Manual
 Filament*1
Used for printing, detailed instruction in unpacking and hardware
assembly chapter of the user manual.

Power Cable
Used to power on the printer, detailed instruction in unpacking chapter of
user manual.
 USB Cable
Used to connect the computer to printer, then print files can be
transfered and printed out, detailed instruction in unpacking and 7.2 print
methods of the user manual.

Filament Guide Tube
Used to guide the filament from the filament spool(after filament
detector) to extruder filament intake, detailed instruction in unpacking
and 4.3 Loading Filament chapter of the user manual.

Quick Start Guide
Used for first print instruction, help you finish your successful first print
quickly.

Grease
Used to lubricate the X,Y, Z axis or other parts, please refer to
flashforge support team before you take maintenance steps,
for printer and user good.

Screwdriver
Used to tighten or untighten the screws and nuts when maintenance,
please refer to flashforge support team before you take maintenance
steps, for printer and user good.
 Allen Wrench (M2.0/2.5)
Used to tighten or untighten the screws when maintenance, please refer
to flashforge support team before you take maintenance steps, for
printer and user good.
 Glue Stick
Used to fasten the model to the build plate when printing, apply the glue
to build plate for a thin layer, make sure model's bottom layers are fine
printed and fastened.

Stamping Wrench
Used to tighten or untighten the nozzle or teflon tube or other parts
when maintenance, please refer to flashforge support team before you
take maintenance steps, for printer and user good.

Unclogging Pin Tool
Used to unclog extruder parts (filament intake, filament feeding wheel,
Finder User Guide | www.flashforge.com
23