FLASHFORGE 3D PRINTER Finder User Manual page 46

①Suppor t Options
Click the Support Options, an option box will appear, supports options include
"treelike"and "linear", when choose "treelike", click [OK], then it will generate
treelike structure; when choose "linear", click [OK], then it will generate linear
structure; if it is a model with supports, when you choose one of the supports options,
software will judge whether existing supports need to be deleted or not on the basis of
the type of existing support, and will pop up the corresponding prompt to let you make
the choice.
②Auto Suppor ts
6-11
Click the [Auto Suppor ts] button, the software will judge the position where supports
are needed and generate corresponding treelike or linear supports. If it is a model with
supports, the existing supports will be deleted and new supports will be generated.
③Add Suppor ts
Supports will be added once clicking the [Add] button. Move the cursor to the
position where supports needed, left-click to choose the starting point of supports, hold
down the left mouse button and drag the mouse the supports preview will show up(if
support surface doesn't need support or the support column angle is too large, will
Finder User Guide | www.flashforge.com
45