Safety; Safety Instructions; Correct Use; Staff Selection And Qualification - Kessel Comfort PLUS Instructions For Installation And Operation Manual

2

Safety

2.1

Safety instructions

De-energise the system and secure it against being switched on again
2.2

Correct use

The control unit has been designed for use with a KESSEL product (pumping station).
If special systems* are operated with this control unit, the requirements listed in the Technical Data chapter must
be fulfilled and observed.
* Pumping stations where pumps and/or sensors or motors for backwater flaps made by manufacturers other
than KESSEL are used.
2.3

Staff selection and qualification

Persons who install the control unit must
– be at least 18 years old.
– have been sufficiently trained and qualified for the respective tasks.
– be familiar with and follow the respective technical rules and safety regulations.
Qualified staff are members of staff who, on the basis of their training and experience as well as their knowledge
of the relevant instructions, valid standards and accident prevention regulations, can carry out the required tasks
and both recognise and avoid any possible hazards.
Work on electrical components may only be carried out by specially trained specialist staff and under adherence
to all the valid accident prevention regulations (UVV).
The control unit is sealed to IP68. No humidity will enter provided the pump is installed correctly. Provide a
fault current circuit breaker
Risk of fire caused by lightning strike. If the control unit is hit by lightning, it could be set on fire. Provide
overvoltage protection in the building.
Safety
26 / 20 V 1.0