Fixture Installation - ADJ HYDRO BEAM X1 User Instructions

Hydro Beam X1
NOTICE: The suitable enviromental temperature for this lighting fixture is between -25˚ C to 45˚ C.
Do not place this lighting fixture in an enviroment where the temperatures are under or above the
temperatures stated above. This will allow the fixture to run at its best and help prolong the fixture
life.
Screw one clamp via a M12 screw and nut into the Omega holder. Insert the quick-lock fasteners of
the Omega holder into the respective holes of the adjustable mounting bracket. Tighten the quick-lock
fasteners fully clockwise. Pull the safety-cable through the opening(s) located on the bottom of the
unit and over the trussing system or a safe fixation spot. Insert the end in the carabine and tighten
the safety screw.
CLAMP AND OMEGA
BRACKET SET UP
SAFETY CABLE
ATTACHMENT POINTS
ADJ Products, LLC - www.adj.com - Hydro Beam X1 User Manual Page 18
SAFETY CABLE
OMEGA BRACKET
ATTACHMENT POINTS

Fixture Installation

CLAMP
OMEGA BRACKET