Installation - ADJ EVS3 User Manual

I N S TA L L AT I O N
DO NOT INSTALL THE PANEL IF YOU ARE NOT QUALIFIED TO DO SO!
INSTALLATION BY QUALIFIED TECHNICIANS ONLY!
INSTALLATIONS SHOULD BE CHECKED BY A QUALIFIED PERSON AT LEAST
ONCE A YEAR!
FLAMMABLE MATERIAL WARNING
Keep panel(s) a minimum of 5.0 feet (1.5m) away from flammable materials and/or
pyrotechnics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or instal-
latons.
A MAXIMUM OF 15 PANELS (20 PANELS if VS1RSB rear support brackets are
used) may be suspended from/stacked upon each other in a vertical column.
There is no limit on the number of panels that may be installed in a single hori-
zontal row. Note that additional processing power may be necessary to operate
larger quantities of panels.
USE CAUTION WHEN POWER LINKING PANELS OF DIFFERENT MODEL TYPES,
AS POWER CONSUMPTION CAN VARY WITH MODEL TYPE, AND MAY EXCEED
THE MAX POWER OUTPUT OF THIS PANEL. CONSULT THE SILK SCREEN FOR
MAX CURRENT RATING.
Input Power
Output Power
Max Power Consumption
• WARNING! The safety and suitability of any lifting equipment, installation location/platform, anchoring/
rigging/mounting method and hardware, and electrical installation is the sole responsibility of the in-
staller.
• Panel(s) and all panel accessories and all anchoring/rigging/mounting hardware MUST be installed fol-
lowing all local, national, and country commercial electrical and construction codes and regulations.
• Before rigging/mounting a single panel or multiple interconnected panels to any metal truss/structure, a
professional equipment installer MUST be consulted to determine if the metal truss/structure or surface
is properly certified to safely hold the combined weight of the panels(s), clamps, cables, and all acces-
sories.
• Inspect metal truss/structure visually to ensure it does not flex and/or become deformed due to the
weight of the panel(s). Damage caused to panel(s) by mechanical stress is not covered by warranty.
• Panel(s) should be installed in areas outside walking paths, seating areas, and areas where unauthor-
ized personnel might reach the panel(s) by hand. Access under work area must be blocked.
• NEVER stand directly below the panel(s) when rigging, removing, or servicing.
• OVERHEAD RIGGING: Overhead fixture installation must always be secured with a secondary safety
attachment, such as an appropriately rated safety cable. Overhead rigging requires extensive experi-
ence, including calculating working load limits, knowledge of the installation material being used, and
periodic safety inspection of all installation material and the fixture itself, among other skills. If you lack
these qualifications, do not attempt the installation yourself. Improper installation can result in bodily
injury and property damage.
AC 100-240VAC, 50/60Hz, 16A Max
AC 100-240VAC, 50/60Hz, 14A Max
120W Max, 48W Average
16