ADJ HYDRO BEAM X1 User Instructions page 13

Hydro Beam X1
LAMP REPLACEMENT WARNING
When the lamp reaches 5700 Hours of usage, the display wll flash the message "Replace lamp soon". This
message will flash for up to 10 minutes. To confirm this warning and return to normal operation, press
the ENTER button.
When the lamp reaches 6000 Hours of usage, the display wll flash the message "Replace lamp now".
This message will flash for up to 10 minutes. To confirm this warning and return to normal operation,
press the ENTER button. NOTE: When the fixture is powered OFF and then back ON again, the
fixture display will flash the following message: "Replace LampNow".
When the lamp reaches 6200 Hours of usage, the display again wll flash the message "Replace lamp now".
The unit will now NO longer respond to DMX commands and enter hibernation mode which will
discontinue all fixture functionality with the exception of a few menu commands. The fixture will
continue to enter into hibernation mode until the lamp is replaced and the lamp time (LAMP ON TIME-R) has
been reset. See page 31 "LAMP ON TIME-R" under the "TOTAL LAMP TIME" submenu.
NOTE: After replacing the lamp, the lamp time MUST be reset. The lamp time must be reset to
gain access to the full system menu.
Lamp Life may vary depending on several factors including but not limited to:
Enviromental Conditions, Power/Voltage, Usage Patterns (On-Off Cycling), Control,
and Dimming.
ADJ Products, LLC - www.adj.com - Hydro Beam X1 User Manual Page 12
Discharge Lamp Warning