ADJ HYDRO BEAM X1 User Instructions page 31

Hydro Beam X1
System Menu: When making adjustments press ENTER to confirm your setup. To exit without
making any adjustments press the MENU button. The display will lock after 30 seconds, press
the MENU button for 3 seconds to unlock.
DMX SETTINGS - The submenus listed under DMX SETTINGS are as follows: DMX Address, DMX
Channel Mode, No DMX Status, and Select Signal.
- DMX ADDRESS - In this submenu you can use the UP or DOWN buttons to adjust and find your
desired DMX address.
- DMX CHANNEL MODE - In this submenu you can use the UP or DOWN buttons to find your
desired DMX channel mode.
- NO DMX STATUS - This submenu setting is used as a precaution mode in case the DMX signal is
lost or interrupted. The operating mode chosen in this submenu is the running mode the fixture
will go into when the DMX signal is lost. Listed below are the 3 modes.
• HOLD LAST - This setting will have the fixture stay in the last DMX setup.
• BLACKOUT - This setting will have the fixture automatically go into stand by mode.
• MANUAL - This setting will go into the current manual control set up. See MANUAL CONTROL.
PERSONALITY - The submenus listed under PERSONALITY are as follows: Select Signal, Status
Settings, WiFly Settings, Reset Motors, Display, and Service.
- SELECT SIGNAL - In this submenu you can select your desired DMX control mode:
• DMX - Control the unit via DMX cable connection.
• WiFly - Control the unit via WiFly.
• WiFly / DMX Out - Control the unit via WiFly connection. The DMX signal is sent to the next unit
via DMX cable.
- STATUS SETTINGS - In this submenu you are able to access and adjust/change: Pan Invert, Tilt
Invert, P./T. Feedback, Pan Degree (no adjustment), P./T. Speed, and Hibernation.
- WIFLY SETTINGS - In this submenu you are able to access and adjust/change: WiFly Channel setting
and Enable/Disable WiFly.
- RESET MOTORS - In this submenu you are able to reset selected motors.
- DISPLAY - In this submenu you are able to access and adjust/change: Backlight Intensity, Display
Invert, Screen Saver Delay, and Display Lock.
- SERVICE - In this submenu you are able to access and adjust/change: calibration setting, USB
power activation, update the software, and restore the factory settings.
NOTE: To update the software please see page 37 for more details.
MANUAL CONTROL - This menu is for manual testing and manual control. Pan, tilt, color wheel,
gobo wheel, prism, prism rotation, shutter, dimmer, and frost can all be tested/adjusted.
ADJ Products, LLC - www.adj.com - Hydro Beam X1 User Manual Page 30
System Menu