Connections - ADJ HYDRO BEAM X1 User Instructions

Hydro Beam X1
When installing the unit, the trussing or area of installation must be able to hold 10 times the weight
without any deformation. When installing the unit must be secured with a secondary safety attachment,
e.g. and appropriate safety cable. Never stand directly below the unit when mounting, removing, or
servicing the unit.
Overhead mounting requires extensive experience, including calculating working load limits, installation
material being used, and perodic safety inspection of all installation material and unit. If you lack
these qualifications, do not attempt the installation yourself.
These installaiton should be checked by a skilled person once a year.
LCD DISPLAY
CABLES
DOWN
* S I D E M O U N T I N G
TO MAINTAIN IP65 RATING INTEGRITY, FIXTURE
MUST BE INSTALLED WITH CABLES FACING THE
GROUND AT ALL TIMES. WATER MUST EASILY
RUN OFF AND NOT COLLECT AROUND CABLE

CONNECTIONS.

The Hydro Beam X1 is fully operational in three different mounting positions, hanging upside-down,
mounted sideways on trussing, or set on a flat level surface. Be sure this fixture is kept at least 12m
(40ft) away from any flammable materials (decoration etc.). Always use and install the supplied safety
cable as a safety measure to prevent accidental damage and/or injury in the event the clamp fails
(see next page). Never use the carrying handles for secondary attachment.
ADJ Products, LLC - www.adj.com - Hydro Beam X1 User Manual Page 19
* S A F E T Y C A B L E
ALWAYS ATTACH A SAFETY CABLE WHENEVER
INSTALLING THIS FIXTURE IN A SUSPENDED
ENVIRONMENT TO ENSURE THE FIXTURE WILL
NOT DROP IF THE CLAMP FAILS.
Fixture Installation
LCD DISPLAY
CABLES
DOWN