ADJ HYDRO BEAM X1 User Instructions page 18

Hydro Beam X1
F I X T U R E I N S T A L L A T I O N
DO NOT INSTALL THE FIXTURE IF YOU ARE NOT QUALIFIED TO DO SO!
Fixture MUST be installed following all local, national, and country commercial electrical and
construction codes and regulations. Before rigging/mounting the fixture to any metal
truss/structure or placing the fixture on any surface, a professional equipment installer
MUST be consulted to determine if the metal truss/structure or surface is properly certified
to safely hold the combined weight of the fixture, clamps, cables, and accessories.
Overhead fixture installation must always be secured with a secondary safety attachment,
such as an appropriately rated safety cable that meets all local, national, and country codes
and regulations.
Fixture ambient operating temperature range is -4° to 113°F. (-20° to 45°C)
Do not use this fixture outside this temperature range.
Fixture should be installed in areas outside walking paths, seating areas, or away from areas
were unauthorized personnel might reach the fixture by hand.
NEVER stand directly below the fixture when rigging, removing, or servicing.
Allow approximately 60 minutes for the fixture to cool down before servicing.
ADJ Products, LLC - www.adj.com - Hydro Beam X1 User Manual Page 17
F L A M M A B L E M A T E R I A L W A R N I N G
Keep fixture at least 5.0 feet (1.5m) away from any
flammable materials, decorations, pyrotechnics, etc.
E L E C T R I C A L C O N N E C T I O N S
A q u a l i f i e d e l e c t r i c i a n s h o u l d b e u s e d f o r a l l
e l e c t r i c a l c o n n e c t i o n s a n d / o r i n s t a l l a t i o n s .
MINIMUM DISTANCE TO OBJECTS/SURFACES
M U S T B E 4 0 F E E T ( 1 2 M E T E R S )
MAXIMUM TEMPERATURE OF EXTERNAL SURFACE
2 1 2 ° F ( 1 0 0 ° C )
Fixture Installation