Installation Of Filters In The Illumination Arm; Installing The Transmitted Light Lamp Housing - Leica DMI Series Instructions Manual

6.8 Installation of Filters in the Illumination
Arm
The Leica DMI Series is equipped with a fi lter mag-
azine to accommodate two 40 mm dia. fi lters as a
standard feature. The fi lters are factory-installed.
To change fi lters yourself, proceed as follows:
• Release the screw (46.1) and remove the cover.
• Place the fi lter in the holder.
• Place the cover on transmitted light illumination
carrier and fasten with the locking screw.
Leica DMI6000 B:
• Activate the fi lters via the Leica Application Suite
(LAS/LAS AF).
Leica DMI3000 B and Leica DMI4000 B:
• Mark the 2 levers with the provided adhesive la-
bels.
Fig. 46 Unscrewing the fi lter holder cover and inserting
fi lters in the transmitted light illumination arm
1 Screw
1
Fig. 48 Lamp housing cabling (cable duct)
6.9 Installing the transmitted Light Lamp
Housing
• Place the lamp housing in the transmitted light
lamp housing mount (Fig. 47), and fasten it with
the clamping screw on the side.
• Thread the cable through the transmitted light
illumination arm (Fig. 48).
• Connect the lamp housing cable to the pow-
er supply for transmitted light on the Leica
CTR4000–7000 electronics box (Fig. 49.1).
Leica DMI3000 B:
• For the DMI3000 B, connect the cable directly
to the back of the microscope.
For instructions on changing the lamp, please
see Chapter 6.10.
These instructions also apply to installing an Hg
lamp on the transmitted light axis. For descrip-
tions of the lamp housings and replacement of
the burner, please see Chapter 6.12, → p. 49ff.
Fig. 47 Mounting the lamp housing on the
transmitted light illumination arm
Fig. 49 Connecting the lamp housing to the
Leica electronics box, example: Leica CTR6000
1
6. Assembly
45