The Smartmove Remote Control Module; Illumination; Transmitted Light - Leica DMI Series Instructions Manual

7. Start-up
Shutter button + Cube buttons 1-6 (Leica
DMI4000 B and Leica DMI6000 B only)
The selected cube is moved to the
loading position for replacement.
„Load" appears on the screen. After
pressing the button (88.2) the draw-
er is opened and the cube can be
changed. The next fi lter cube will be
moved to the loading position after
the drawer is closed.

7.5 The SmartMove Remote Control Module

SmartMove knobs
(Leica DMI4000 B and Leica DMI6000 B)
Use the knobs 89.1 and 89.2 to move the stage in
X and Y directions.
The image is focused using the knob 89.3 (Leica
DMI6000 B only).
The height of the knobs can be adjusted to a
comfortable working position by turning 89.4.
Variable function buttons on SmartMove
The variable function buttons are assigned func-
tions at the factory that are appropriate to the
features of your microscope. They are labeled
accordingly. For details on button assignments,
please refer to the included identifi cation sheet.
For information on the abbreviations used, please
refer to the list → p. 64.
Note:
The Leica Application Suite (LAS) software is re-
quired for changing the button assignments.
70

7.6 Illumination

7.6.1 Transmitted light

If your microscope has not yet been set up for
Koehler illumination, please continue with the
„Koehler Illumination" section.
Leica DMI3000 B:
• If necessary, adjust the TL bright fi eld position
at the fi lter slider.
• Select an objective with moderate magnifi ca-
tion (10x–20x).
• Set the condenser to the bright fi eld position.
• Place a specimen on the stage.
• Focus on the specimen using the focus wheels.
• Adjust the light intensity.
• Close the fi eld diaphragm manually until the edge
of the diaphragm appears in the fi eld of view.
Fig. 89 SmartMove remote control module
1 Travel in x
2 Travel in y
3 Focus
4 Individual adjustment of button height
5 Variable function buttons (factory preset)
1
2
3
4
5