Otto Bock 3F1-1 Instructions For Use Manual page 35

15
16
Preparing the charging unit for the Genium
Complete the following steps to assemble the charging unit for the Genium:
17
2) Cut off the sheath at the top with an over­
hang of 6 cm.
3) Secure the sheath on the inside of the
foam with contact adhesive.
INFORMATION: Note the setting time
of the contact adhesive depending on
the application thickness and temper­
ature.
4) Leave the sheath hanging in the ankle
area. The sheath must not be glued or cut
off in the ankle area.
5) Punch the 4 holes for the tube adapter
screws in the sheath as well.
INFORMATION: Apply contact adhesive
to the holes to prevent runs in the
sheath.
1) Make a longitudinal cut in the sheath.
INFORMATION: The slit has to be
above the opening in the foam.
35