Ford COUGAR 1968 Shop Manual page 695

PART 16- 1
-
Ventilating System a n d Heater 16-9
HEATER CONTROL
ASSEMBLY-FAIRLAN E
1. Remove the instrument panel
pad (Part 18-1).
2. Remove the defrost and temper-
ature control knobs. Disconnect the
defrost and temperature control cables
at the control.
3. Remove the heater control
mounting screws and remove the
control.
4. Position the control and in-
stall the mounting screws. Clamp the
harness under two of the plastic
clips.
5. Connect and adjust the defrost
and temperature cables.
6. Install the control knobs.
HEATER TEMPERATURE
CONTROL AND/QR DEFROSTER
CONTROL CABLE-COUGAR,
MUSTANG
REMOVAL
1. Disconnect the battery ground
cable.
2. Remove the four screws retain-
ing the heater control assembly to the
instrument panel and position the con-
trol assembly outward.
3. Remove the two control cable
retaining screws.
4. Remove the glove box liner re-
taining screws and remove the glove
box liner.
5. Remove the retaining clamp and
screw on each of the three cables a t
the crankarm.
6. Remove the complete control
cable assembly (heater air, tempera-
ture and defroster cables).
INSTALLATION
1. Position the new cable assembly
to the heater and install the retaining
clamp and screw.
2. Pcsition the cable assembly to
the heater control assembly and in-
stall the two retaining screws.
3. Position the control assembly to
the instrument panel and install the
four retaining screws.
4. Loosen each control cable
clamp a t the crankarm. Adjust the
cable length at each crankarm to
obtain full off position with ]/&inch
overtravel to insure a positive shut
off.
5. Connect the battery ground
cable.
HEATER TEMPERATURE
CONTROL CABLE AND/OR
DEFROSTER CONTROL
CABLE-FAIRLANE
1. Disconnect the battery ground
cable.
2. From under the instrument panel,
remove the cable(s) from the control
head. Loosen, but do not remove the
control cable clamp retaining screw(s)
at the heater plenum chamber.
3. Remove the cable(s) from the
heater plenum chamber crankarms.
4. T O INSTALL: Position the
cable(s) on the control head and on
the plenum chamber crankarms.
5. Adjust the cables for proper
operation and tighten the retaining
clamvs a t the vlenum chamber.
6. Connect the battery ground
cable.
HEATER TEMPERATURE
CONTROL CABLE AND/OR
DEFROSTER CONTROL
CABLE-MONTEGO
REMOVAL
1. Disconnect the battery ground
cable.
2. Remove the glove compartment
liner retaining screws and remove the
liner.
3. Remove the instrument panel
pad. Refer to Group 18, Part 1 Sec-
tion 3.
4. Disconnect the control cable
at the control head and at the heater
plenum chamber. Remove the cable
(Fig. 1 1).
INSTALLATION
1. Position the control cable to
the control head and to the lever on
the plenum chamber (Fig. I I).
2. Adjust the control cable length
for proper operation (Refer to adjust-
ment procedure, Section 3).
3. Install the instrument panel
pad and the glove compartment liner.
4. Connect the battery ground
cable.
BLOWER SWITCH-COUGAR
MUSTANG
REMOVAL
1. Disconnect the battery ground
cable.
2. Remove the screws retaining
the heater control to the instrument
panel and position the control out.
3. Remove the heater switch con-
trol knob.
4. Disconnect the plug connector
FIG. 7
]--Heater Controls-Montego