Ford COUGAR 1968 Shop Manual page 382

8-98
GROUP 8
-
Engine
ENGINE FRONT SUPPORT
UPPER BRACKET
6A069 L.H. 6043 R.H.
ENGINE FRONT SUPPORT
L W E R BRACKET
6A095 L.H. 6A094 R.H.
A2501-B
FIG. 22-Engine Front Supports-Mustang and Cougar With
390 or 427 V-8
376905.52
SUPPORTING CROSSMEMBER'-5059
-*c,L//C
INSULATOR ASSEMB
FIG. 23-Engine Rear Support-Fairlane, Falcon and Montego With
390 or 427 V-8
ENGINE FRONT S U P P O R T
taining bracket to one side. Remove
INSULATOR-MUSTANG the insulator.
AND COUGAR
The engine front support insulators
Installation
are shown in Fig. 22.
Removal
1. Raise the vehicle on a hoist.
2. Remove the horizontal through
bolt, washer and nut, retaining the
insulator assembly to the engine front
support lower bracket.
3. Position a jack and wood block
under the oil pan and raise the engine
so the insulator clears the lower
bracket.
4. Remove the bolts, washers and
nuts retaining the insulator to the
engine front support upper bracket.
5. On a right insulator support, po-
sition the starter cable and its re-
1. Position the insulator to the en-
gine front support upper bracket, and
install the retaining bolts, washers and
nuts
On a right insulator, position the
starter cable and its retaining brack-
et before installing the retaining bolts,
washers and nuts. Torque to, specifi-
cations.
2. Lower the engine and install
the thru bolt, washer and nut retain-
ing the insulator to the frame brack-
et. Torque the bolts to specifications.
3. Remove the jack and wood
block and lower the vehicle.
SUPPORTING CRMSMEMBER-5059.
FOR XPL TRANSMISSION
INSULATOR ASSEMBLY-6068
TRANSMISSIONS
FIG. 24-Engine Rear Support-
Mustang and Cougar With 390
ENGINE REAR S U P P O R T
INSULATOR-FAIRLANE,
FALCON AND MONTEGO
WITH 390 or 427 V-8
The engine rear support is shown
in Fig. 23.
Removal
1. Position a jack under the trans-
mission extension housing. Remove
the insulator assembly to crossmem-
ber support bracket retaining bolts
and nuts. Remove the insulator to
transmission extension housing bolts
and lock washers.
2. Raise the transmission exten-
sion housing and remove the insulator.
Installation
1. Position the insulators to the
crossmember and install the nuts and
washers.
2. Lower the transmission exten-
sion housing.
3. install the insulator to trans-
mission extension housing bolts and
lock washers. Torque all bolts and
nuts to specifications. Remove the
jack.