Ford COUGAR 1968 Shop Manual page 223

PART 7-2
-
C4
Automatic Transmission
7- 35
Tool- 1501-1 00-A
FIG. 28
- Removing Extension Housing
Seal
EXTENSION HOUSING
/
BUSHING
I
Tool-T57P-7697-0
FIG. 29
- Removing Extension
Housing Bushing
EXTENSION HOUSING AND
GOVERNOR REPLACEMENT
1. Raise the vehicle on th'e hoist.
2. Remove the drive shaft. Posi-
tion the transmission jack to support
the transmission.
3. Remove the speedometer cable
from the extension housing.
4. Remove the extension housing
to crossmember mount attaching
FIG. 30
-
Installing Extension
Housing Bushing
bolts. Raise the transmission and re-
move the mounting pad between the
extension housing and the crossmem-
ber.
5. Loosen the extension housing
attaching bolts to drain the trans-
mission fluid. Disconnect the exhaust
inlet pipes a t the manifold and lower
the inlet pipes.
6. Remove the six extension hous-
ing-to-case attaching bolts and re-
EXTENSION HOUSIN(
GOVERNOR GOVERNOR
GOVERNOR
BOLTS (41 DISTRIBUTOR
DISTRIBUTOR
FIG. 32
-
Governor Installed
move the extension housing.
7. Remove the governor housing-
to-governor distributor attaching bolts
(Fig. 32). Remove the governor housing
from the distributor.
8. Refer to Major Repair Opera-
tions for governor repair operations.
9. lnstall the governor housing on
the governor distributor (Fig. 32).
Install the attaching bolts and torque
the bolts to specification.
10.
Install a new extension hous-
ing gasket on the case. Install the
extension housing and six attaching
bolts. Torque the bolts to specifica-
tion.
11. Install the transmission mount-
ing pad to the crossmember. Lower
the transmission and install the ex-
tension housing-to-crossmember at-
taching bolts. Torque the attaching
bolts to specification. Remove the
transmission jack.
12. Connect the speedometer ca-
ble to the extension housing. Install
the drive shaft.
13. Install the inlet pipes on the
manifold.
FIG. 31
-
lnstalling Extension Housing
Seal
D1027-C
14. Lower the vehicle and fill
the transmission with fluid.
15. Check the extension housing
area for fluid leakage.
3
REMOVAL AND INSTALLATION
REMOVAL
1. Raise the vehicle and remove
the two converter cover attaching bolts
at the lower front side of the con-
verter housing. Remove the cover.
2. Remove the two converter
drain plugs (Fig. 33). Drain the fluid
from the converter. lnstall the two
converter drain plugs.
3.
Remove the drive shaft and
install the extension housing seal re-
placer tool in the extension housing.
4. Disconnect the vacuum hose
from the transmission vacuum unit.
Disconnect the vacuum line from the
retaining clip.
5. Remove the two extension hous-
ing to crossmember bolts.
6.
Disconnect the speedometer
cable from the extension housing.
7. Disconnect the exhaust pipe
flange from the manifolds.
8. Remove the parking brake cable
from the equalizer lever.
9. Loosen the transmission fluid
pan bolts and drain the fluid at one