Ford COUGAR 1968 Shop Manual page 261

PART 7-3
- C6
Automatic Transmission
7-73
screws and remove the gauge pin.
Check for starting in the park
position.
11.
Turn the ignition key to the
ACC position and place the selector
lever in the reverse position and
check the operation of the back-up
lights. Turn the key off.
12. Position the selector lever re-
tainer to the selector lever housing. In-
stall the six attaching screws.
13.
Install the cover and dial in-
dicator.
14.
Install the trim panel on the
top of the console. Install the selector
lever handle.
MUSTANG-COUGAR
NEUTRAL STA
SWITCH
\
I
I
TOOL
-
T 59 ~ 1 7 7 3 7 0
-
B
D1597- A
FIG.
27-Neutral S t a r t Switch-
1. With the manual lever properly
FIG.
22-Adjusting Intermediate
adiusted. loosen the two switch at- Mustang "'gar Band
taihing bolts (Fig. 21).
2. With the transmission manual
lever in neutral, rotate the switch
and insert the gauge pin (No. 43
drill shank end) into the gauge pin
holes of the switch. The gauge pin
has to be inserted to a full 31/64
inch into the three holes of the
switch (Fig. 21).
3. Torque the two switch attach-
ing bolts to specification. Remove
the gauge pin from the switch.
4. Check the operation of the
switch. The. engine should start only
with the transmission selector lever
in Neutral and Park.
NEUTRAL START SWITCH
REPLACEMENT
MONTEGO AND FAIRLANE
Column Shift
1. Disconnect the neutral start
switch wires at the plug connector.
2. Remove the two screws securing
the neuGal start switch to the steer-
ing column and remove the switch.
Remove the actuator lever from the
steering column i f equipped with a
Type I1 switch (Fig. 19).
3. Position the neutral start
switch on the steering column and
install and tighten the two attaching
screws.
4. Connect the switch wires to
the plug connector.
5. Check the operation of the
switch in each selector lever position.
The starter should engage in only the
neutral and park positions.
Console Shift
I. Remove the selector lever handle
from the lever.
TRANSMISSION
7
CASE
SEAL-7W24
I
1
SEAL.
SPRING
1
GASKET,
7D026
FIG.
23-Servo Disassembled
2.
Remove the trim panel from the
top of the console.
3. Remove the cover and dial in-
dicator as an assembly.
4. Remove the six screws that se-
cure the selector lever retainer to
the selector lever housing. Lift the
retainer from the housing.
5. Remove the two screws securing
the neutral start switch to the se-
lector lever housing. Disconnect the
neutral start switch wires at the plug
connector and remove the switch.
6.
Position the neutral start switch
to the selector lever housing and in-
stall the two attaching screws.
7. With selector lever. in neu-
tral, move the selector lever back
and forth until the gauge pin (No. 43
drill) can be fully inserted into the
gauge pin holes (Fig. 20).
8. Place the transmission selec-
lor lever firmly against the stop of
the neutral detent position.
FIG.
24-Governor Installed
9. Slide the combination starter
neutral. and back-up light switch for-
ward or rearward as required, until
the switch actuating lever contacts
the selector lever.