10-62
.
.
GROUP 10
-
Fuel
System
3. Position the air horn gasket on
the main body, with the fuel bowl vent
hole in the gasket located opposite
the fuel inlet.
4. Position the air horn over the
main body and insert the end of the
choke. plate rod into the automatic
choke lever. Install the air horn re-
taining screws arid the carburetor iden-
clearance (pull-down). vent valve ad-
tification tag. Tighten the retaining
justment (if so equipped) and fast idle
screws. Install the choke plate rod
cam linkage adjustment. Perform a
retainer. Install the air cleaner anchor
fuel level float adjustment (wet) after
screw.
the carburetor has been installed on
5. Refer to Part 10-1, Section 2
thecar.
I
Common Adjustments and Repairs
and perform the automatic choke plate