Ford COUGAR 1968 Shop Manual page 239

PART 7-2
-
C4
Automatic Transmission
7-5 1
Handle Tool
-
T66.L-7003.85
Tool
-
T66L-7003.88
Tool
-
T66L-7003-82
REMOVAL
FIG. 93
-
Replacing Forward Clutch Hub Bushing
FIG. 96
-
Replacing Sun Gear
Bushing
2. Place the one-way clutch outer
EXTERNAL SNAP RING
race inside the case. From the back
of the case install the six outer race
to case attaching bolts. Torque the
bolts to specification with the tools
shown in Fig. 103.
3. Place the transmission case in
a vertical position with the back face
of the case upward. Install the park-
ing pawl retaining pin in the case
(Fig. 104).
4. Install the parking pawl on the
case retaining pin. Install the park-
ing pawl return spring as shown in
Fig. 104. -
5. Install thrust washer No. 10
on the parking pawl gear (Fig. 105).
Place the gear and thrust washer on
the back face of the case (Fig. 104).
6. Place the two fluid distributor
tubes in the governor distributor sleeve.
Install the distributor sleeve on the
case. As the distributor sleeve is in-
stalled, the tubes have to
be
inserted
INTERNAL SNAP RING
/
FIG. 94
-
Removing or Installing
Sun Gear External Snap Ring
in the two holes in the case and the
parking pawl retaining pin has to be
inserted in the alignment hole in the
distributor sleeve.
7. Install the four governor dis-
FIG. 95
-
Input Shell and Sun Gear Disassembled
G E A R
SNAP RlNG
H U B AND FLANGE D1433-A
FIG. 97
-
Reverse Rina Gear and
-
Hub Disassembled
tributor sleeve-to-case attaching bolts
and torque the bolts to specification.
8. Install the governor distributor
assembly on the output shaft. Install
the distributor retaining snap ring.
Fig. 106 shows the correct snap ring
that is to be used.
Tool
-
,Handle
FIG. 98
-
Installing Low and
Reverse Brake Drum Bushing
EXTERNAL SNAP RlNG
INPUT. S H E L L
\