Ford COUGAR 1968 Shop Manual page 237

PART 7-2
-
C 4 Automatic Transmission 7 - 4 9
RETAINER
\
CLUTCH
FIG. 86
- Checking Reverse-High
Clutch S n a p Ring C l e a r a n c e
i p s
Tool T 6 5 L - 7 7 5 1 5 - A D 1591-A
FIG.
82
-
Removing o r Installing Clutch Piston Spring Retainer S n a p Ring
FIG.
83
-
Removing Reverse-
High Clutch Piston
FIG.
85
- lnstalling Reverse-High
Clutch Bushing
C o p t
C h ~ s e l
D 1 7 3 4 - A
FIG. 84
-
Removing Reverse-High
Clutch Bushing
end of the sun gear with the tool
8. Install the external snap ring
on the sun gear (Fig. 94).
REVERSE RING
GEAR AND HUB
1. Remove the hub retaining snap
ring from the reverse ring gear.
2. Remove the hub from the re-
verse ring gear (Fig. 97).
3. Install the hub in the .reverse
ring gear. Make sure the hub is fully
seated in the groove of the ring gear.
4. .Install the snap ring in the re-
verse ring gear. Make sure the snap
ring is fully seated in the snap ring
groove of the ring gear.
SNAP RING
1 '
*%
\
FIG. 87
- Removing Forward
Clutch Pressure Plate S n a p Ring
the cape chisel and cut along the
bushing seam until the chisel breaks
through the bushing wall. Pry the
loose ends of the bushing up with an
awl and remove the bushing.
2. lnstall a new bushing with the
tool shown in Fig. 98.
GOVERNOR AND
OIL DISTRIBUTOR
I. Remove the rings from the
governor oil distributor (Fig. 99).
2. Remove the governor housing
to distributor attaching bolts. Re-
move the governor from the oil dis-
tri-butor. Remove the governor oil
screen.
3.
Remove the primary governor
valve retaining ring (Fig. 100). Re-
move the washer, spring, and pri-
mary governor valve from the
housing.
4. Remove the secondary govern-
or valve spring retaining clip, spring,
and governor valve from the housing.
5. Install the secondary governor
valve in the housing. Install the
-
shown in Fig. 96. spring and retaining
tip.
Make sure
6. Install the internal snap ring LOW AND REVERSE the clip is installed with the small
on the sun gear. Install the sun gear BRAKE DRUM BUSHING concaved area facing downward, to
in the input shell. hold the spring in the correct position.
7. Install thrust washer No. 5 on 1 . Replace the low and reverse
6. Install the primary governor
the sun gear and input shell (Fig. brake drum bushing if it is worn or valve in the housing. Install the spring,
95). damaged. T o remove the bushing, use washer and retaining ring. Make sure