Ford COUGAR 1968 Shop Manual page 677

15-62
GROUP
15-5-Lighting System, Horns and Instruments
3
IN-VEHICLE ADJUSTMENT
WINDSHIELD WASHER
NOZZLE ADJUSTMENT
The adjustment of the single or dual
nozzle can be accomplished by bending
the nozzle tube to provide desired
windshield washer fluid distribution.
WINDSHIELD WIPER
BLADE ADJUSTMENT
Turn the ignition switch to the ac-
cessory position momentarily, with
the wiper switch off. After bringing
the pivot shafts to their park posi-
tions, install the wiper blades so
that they lie flat against the lower
edge of the windshield.
WIPER MOTOR PARK
SWITCH ADJUSTMENT
With jumper wires connected as
shown in Fig. 14, the'motor should
move to the park position. If it does,
the motor is all right and the fault
lies in the panel switch or wiring. If
the motor does not park, replace the
windshield wiper motor.
FIG. 14
-
Windshield Wiper Motor Park Switch Test
WINDSHIELD WASHER
nect the hose. Check the operation
PUMP-COUGAR A N D MUSTANG the pump'
1. Open the hood and disconnect
the hose from the reservoir and plug
the reservoir opening.
2. Remove the screws retaining the
left side cowl panel and remove the
panel (it will be necessary to loosen
the screws retaining the scuff plate
to allow for the removal of the cowl
panel).
3. Remove the four screws retain-
ing the pump assembly to the dash
panel. Disconnect the two hoses and
one multiple connector from the pump
and remove the pump.
4. Connect the two hoses and one
multiple connector to the pump. Po-
sition the pump assembly to the dash
panel and install the four retaining
screws.
5. Position the cowl panel and
install the retaining screws. Also
tighten the scuff plate screws.
6.
Unplug the reservoir and con-
WINDSHIELD WASHER
,
PUMP-FALCON, FAIRLANE
A N D MONTEGO
1. Disconnect the washer pump
wiring connectors.
2. Kemove the lnlet and outlet
hoses from the washer pump. Position
the inlet hose upward to prevent drain-
ing the washer reservoir.
3. Remove the two screws which
retain the washer pump to the fender
apron and remove the washer pump.
4.
Position the washer pump to
the fender apron and install the two
retaining screws.
5. Connect the inlet and outlet
hoses to the washer pump.
6;
Connect the washer pump wir-
ing connectors.
WINDSHIELD WIPER
MOTOR-FALCON, FAIRLANE
A N D MONTEGO
1. Disconnect the wiper motor wir-
ing connector.
2. Remove the wiper arm and
blade assemblies.
3. Remove the cowl top grille panel
retaining screws and remove the cowl
top grille.
4. Remove the wiper link retaining
clip from the wiper motor arm.
5. Remove the four wiper motor re-
taining bolts and remove the wiper
motor and mounting bracket.
6.
Transfer the wiper motor mount-
ing bracket and related parts to the
replacement wiper motor.
7. Position the wiper motor and
mounting bracket to the dash panel
and install the four retaining bolts.
8. Position the wiper link on the
motor drive arm and install the retain-
ing clip.
9.
Install the cowl top grille panel.