Table of Contents
Advertisement
How to Install Multiple QC-S30F Collators
4.
Attach the bin shelves, beginning at the
bottom by following the steps below.
(1) On the drive side of each bin shelf, an arm fits
under a pin inside the machine. A pin on the bin
shelf fits into a notch in the frame of the machine.
(2) On the near side of the machine, fit the arm under
the pin inside the machine. A pin on the bin shelf
fits into a U-shaped cutout on the machine frame.
(3) Swing the bin shelf down to lock it in position.
(4) Install all of the other bin shelves by repeating the
steps 1 through 3.
5.
Plug the power cord into the QC-S30F.
6.
Plug the power cord into an outlet.
Important
• Plug the power cord into a properly-grounded outlet.
• If you must use an ungrounded outlet, be sure to
ground the machine separately. A poor ground can
cause problems for the machine due to by static
electricity, lightning strikes, or current leakage.
• Do not attach the ground to a gas pipe.
53
WARNING
Pin
U-shaped Cutout
* When connecting three collators, repeat
these steps to connect the two QC-S30F's.
* After the installation is complete, set the AC
power supply frequency for each unit. See
the "QC-S30F Frequency Setting" instruc-
tions which are shipped with each machine.
Arm
21098
50101D1
Arm
Pin
21098
50101E1
BIn Shelf
21098
50101F1
Power Cord
21098
50202W1
Advertisement
Chapters
Table of Contents
