Friction Pads - Horizon Fitness QC-S30 Important Information Manual

Maintenance: Friction Pads
Double feeding or jamming may occur if a friction pad is dirty. This can prevent the sheets from being transported smoothly.
Frequency: Once every 3 months or when not using for 6 months
Friction Pad
Friction Pad
c
!
21098
40201A1
1
2
Roller Shaft
21098
40202A1
Friction Pad
21098
40202B1
U-shaped Cutout
Projection
21098
40202C1
Cleaning and Replacing a Friction Pad
WARNING
Turn off the main power switch and
unplug the power cord whenever a friction
pad is cleaned or replaced.
Turn off the power switch
• Turn off the main power switch for the QC-S30 and
unplug the power cord.
Remove the roller shaft.
• Pull the shaft and feed roller toward the near side of
the machine.
• Pull out the right end of the shaft.
Lift the friction pad up.
• Clean the surface of the pad using a cloth with rub-
ber cleaner (XPF-111).
CAUTION
When using rubber cleaner, wear rubber
gloves or clean your hands after finishing
the cleaning operation.
Important
• If double-feeding or jamming occurs often even if
the friction pad has been cleaned, the pad may be
worn. Replace the pad with a new one.
Install the friction pad and the roller shaft.
• When re-assembling, insert the projection on the
roller shaft into the U-shaped cutout on the fixed
end of the shaft.
32