Horizon Fitness QC-S30 Important Information Manual page 56

How to Install Multiple QC-S30F Collators
Attach the upper conveyor to the middle
conveyor.
(1) Insert the four pins on the upper conveyor into the
U-shaped cutouts on the middle conveyor.
Connecting the QC-S30 and the QC-S30F
(1) Attach the rear cover on the QC-S30F using two
screws.
(2) Remove three screws on the lower left cover of the
QC-S30.
(3) Attach conveyor support plate using the three
screws removed in step (2).
• Fasten the three screws in the tops of the holes so that
the conveyor support plate is positioned as low as
possible.
(4) Lift up all of the conveyors and insert the two
positioning pins on the conveyor support plate into
the two holes on the bottom of the conveyor.
• When inserting the positioning pin, move the QC-S30.
(5) Attach the lower conveyor using the conveyor
locking plate using two mounting screws.
51
Middle
Conveyor
U-shaped
Cutout
Rear Cover
QC-S30F
Lower Left Cover
Bottom
of Set
Conveyors
Upper
Conveyor
21098
50202M1
21098
50202N1
Conveyor
21098
Support Plate
50202O1
Positioning
Pins
21098
50202P1
Bottom of Conveyor
Assembly
Conveyor Locking Plate
21098
50202Q1