Maintenance: CT-S30 Delivery Unit for Side Stapling
If the delivery guides are dirty, the collated sheets may stop or move slowly in the delivery unit for the side stapler.
Frequency: Once every 6 months
Receiving Tray
Rear Guides
21098
20201A1
Locking Screw
Upper Delivery Guide
Lower Delivery Guide
21098
40206A1
Upper Delivery Guide
Lower Delivery
Guide
21098
40206B1
Cleaning the CT-S30
WARNING
If the delivery gates are dirty, the collated
sheets may stop or move slowly in the
delivery unit for side stapling.
Turn off the power switch
• Turn off the power switch for the collator and unplug
the power cord.
Increase the gap between the upper deliv-
ery guide and the lower delivery guide.
• Increase the gap for the delivery guides by loosen-
ing the locking screws for the upper delivery guide
in the CT-S30.
Clean the delivery guides.
• Clean the delivery guides with a cloth soaked in
alcohol.
• Adjust the angle of the upper delivery guide so that
the distance between the upper delivery guide and
lower delivery guide is about 5 mm (0.2"). After
making this adjustment, tighten the screws for the
upper delivery guide.
36