Horizon Fitness QC-S30 Important Information Manual page 23

Offset Receiving Straight Receiving
Stacking Area:
Stacking Area:
Width x Length: 138 x 175 mm
Width x Length: 180 x 175 mm
(7.1" x 6.9") or more (5.5" x 6.9") or more
Width x Length: 300 x 432 mm Width x Length: 305 x 432 mm
(11.8" x 17.0") or less (12.0" x 17.0") or less
Backstop
Front Front
50 mm (2")
Guides Guides
c
!
When feeding non-standard size sheets on either the
short or long edge:
Load the sheets into the bins.
• Load the sheets into the bins in the position shown in
the illustration to the left.
• If the long edge of the sheet is 420 mm (16.5") or more,
pull out the bin support.
Bin Support
21098
30401C1
Set the receiving tray.
• Offset Receiving
(1) Position the backstop. Set the front guides 50 mm (2")
away from the edge of the stack.
Backstop
(2) If the backstop and front guides do not support the
stack, use the support stopper.
• Straight Receiving
(1) Position the rear guide to the near side.
(2) Position the backstop and the front guides against the
edges of the sheet as it sits on the receiving tray.
(3) If the backstop and front guides do not support the
21098
stack, use the support stopper.
30301E1
Select the receiving mode.
• Select offset receiving or straight receiving using the fin-
isher/stacker select button.
Start the collating operation.
Finisher/Stacker
Select
• If the sheets are not stacked correctly because of
static electricity, reset the backstop 10 to 20 mm (0.4
to 0.8") away from the edge of the stack.
21098
20301B1
Important
18